Your Web Site Name

 Installation Instructions

Parts Included:

1. Pull Station Protector
2. Bag of screws and anchors

Required Tools:

1. Phillips screw driver
2. Level
3. Drill with ¼” drill bit
4. Utility knife if performing an installation on an existing pull station

New Installation

• Align the Pull Station Protector over the wall opening were the pull station is going to be installed.
• Level the Pull Station Protector and mark each corner.
• Remove the Pull Station Protector.
• Drill the marked holes with the ¼” drill bit.
• Place the provided anchors into the holes.
• Place the Pull Station Protector over the box.
• Set the provided screws into the anchors and tighten.
• Installation complete.

Existing Installation

• Remove the center plate along the perforated line with a utility knife.
• Place the Pull Station Protector over the existing pull station.
• Level the Pull Station Protector and mark each corner.
• Remove the Pull Station Protector.
• Drill the marked holes with the ¼” drill bit.
• Place the provided anchors into the holes.
• Place the Pull Station Protector over the pull station aligning all corners.
• Set the provided screws into the anchors and tighten.
• Installation complete.